Pipe cutting machine, auxiliary accessories, power distribution cabinet. Auxiliary body can be selected according to different production needs: multi-color printing machine, slitting machine, rewinding machine, beating machine, pipe drawing machine, etc. In order to produce better products, a pipe cutting machine is recommended.
There are precautions for installation and adjustment
1. Install the front frame, middle frame, and rear frame on the reserved plane in the predetermined position, and align it horizontally to firmly contact with the foundation, so that the center line of the frame is in a straight line in the longitudinal direction; The rack shifts, shakes, etc. to avoid accidents.
2. Install the configured oven on each rack in sequence, and fix it with bolts; keep the oven and rack level and stable.
3. Install the power distribution cabinet next to the front rack or in a place that is convenient for operation. Follow the instructions to connect each circuit, and finally connect the power supply (be sure to disconnect the power supply when wiring).
4. Install each internal configuration according to the set position, and adjust each media roll, unwind roll, rewind roll, etc. horizontally, the axes are parallel to each other and perpendicular to the direction of tape movement. During the installation process, the smooth surface of the media should not be scratched, and the correct installation of the various components should be maintained.
5. Install the gears, pulleys, and sprockets, and try to rotate them properly to ensure that the rotation is flexible and there is no abnormality or blocking; and add corresponding lubricating oil to the chain, reducer, etc.
6. Check whether there are any omissions in the installation, and ensure that the heater, thermal sensor, and transmission media are installed; check whether the circuits are connected correctly and the wires are not leaking; whether the entire body is offset incorrectly, and the oven has gaps.
7. After the installation is correct, start the test machine one by one. If there is any abnormality, stop the machine immediately for inspection and adjustment; start production after confirmation (please pay attention to personal safety and machine safety during operation).
