CNC hook winding machine consists of two parts: counting speed regulation and mechanical and electrical control.
The counting speed regulation section is mainly composed of a controller, winding motor, speed regulating circuit, dry spring sensor, counter, counter circuit, and input given.
The mechanical and electrical control part is composed of electromechanical control, line mechanism, and file jumping mechanism.
The counting speed adjustment part is mainly used to control the motor of the winding machine, and then the number signal of the winding motor is sent to the binary addition counter by the dry spring sensor.
When the number of meters is consistent with the number of input-given rings, the signal is sent to the controller from the matching circuit to control the electrical circuit.
The mechanical and electrical control part is transmitted by various relays, micro-switch, etc. to control the discharge mechanism and file jumping mechanism through electrical appliances, so as to complete the automatic discharge and automatic file jump tasks.
The wire crossing mechanism in the configuration component of the wire winder is a component that directly contacts the wires such as the lacquer bag.
The selection of the structure and material of the component will affect the wear of the wires and the smoothness of the wiring. Different wiring winding processes The configured wire cross-wire mechanism materials are different.
The selection and application of automatic winding wire guidelines The selection and application of mechanism materials According to different models and different winding requirements, the commonly used materials are the following categories: tungsten steel, ceramics, nylon, and copper.
The differences in these types of materials are very large The application surface also has its own Qianqiu; tungsten steel is generally used in the material that is relatively hard and has a smaller winding process on the surface wear. Ceramics is a common material in automatic winding machines. This type of material is generally used in cross-wire and wire mechanisms. Ceramic wire wheels, porcelain eyes, and solid wires are used. Nylon is a very wear-resistant non-metallic material. The line mechanism can be very good in the protection line material.
The choice of material for the automatic winding wire guideline is not static. The introduction of many new materials and new processing processes makes the selection of materials more diversified.
