There are some requirements in the installation of the fully automatic winding machine! Small and medium-sized winding machines need to be relatively strong workbenches. It is necessary to install appropriate shock absorption devices in the workbench. If the number and distribution position of the wound machine installation of the fulcrum is not reasonable, or the fixed method is unreasonable, it will affect the whole machine will affect the whole winder machine.
For companies using winding machines, the requirements for the site are to build a foundation or workbench that is suitable for winding equipment and resettlement to meet the requirements of the venue environment of the winding machine. The specific requirements generally have the following points:
1. The winding machine workbench and the foundation are compatible with the base of the model winding machine, and the winding machine installed on it is firm and reliable. There is reliable grounding equipment around it, and there is no large source of interference around.
2. The winding machine workbench and foundation should have sufficient strength and stiffness to avoid severe vibration when the winding machine is moving at high speed. Nearby equipment and buildings do not have a bad effect on winding machines.
3. The workbench and foundation of the winding machine should have stability and durability, be waterproof, anti-slip, and harmful objects, and have no deformation or local sinking. When the winding machine is placed in an environment where chemical liquids, oils, or corrosives are placed, the foundation should be added with protective layers. For example, coat acid-proof and oil-proof cement slurry sand on the surface of the foundation, and set up drainage and liquid grooves.
4. The center of gravity of the winding machine and the general center of gravity of the workbench and foundation are located on the same vertical line as the center of the foundation.
The winding machine of the winding machine manufacturer is driving the skeleton rotation by the main axis. It is combined with the three-dimensional mechanism space to control the lacquer cable so that the lacquer cable is arranged by a spiral line in the outer layer of the skeleton, which is usually used for transformers and inductance coils. The skeleton is fixed when the flying winding winding machine is wrapped. The side spindle is used to drive the flying fork rotation to wrap the lacquer cable on the outer groove of the skeleton, which is usually used for the motor rotor and cross-icon coil.
