Shallow automatic winding machine manufacturer winding machine operation taboo
Moving coil winding machine general common function has several default, automatic parking, direction, coiling, automatic cross slot, etc., in actual use, the points should be paid attention to First is rev around slowly and stop the local train, and around the local train this feature is slow after the start operation in order to reduce the tension structure and the impact of the enameled wire, can according to the actual need to set the general situation for 1 to 3, Local train parking function is the equipment before the end winding step sequence local train running, this function can help to reduce the impact on the brakes makes smooth end winding equipment, especially need accurate positioning of the winding process, this parameter must be set, depending on the equipment running speed, parameters should be adjusted generally for two to five laps, again is line direction and winding direction, These two parameters are the setting of the displacement direction of the line and the rotation direction of the spindle respectively.
Automatic winding vendors would row axis and spindle of the automatic winding machine is controlled by the controller, there is a particular relationship, must make when setting spool displacement direction, many users are reflected when debugging equipment alarm, this is because the error caused by equipment protection, coiling machine has detecting zero, used for fixing the row of spool, if from zero to start the equipment, Then the spool must move outward. If it is incorrectly set to move inward, the equipment will alarm. The rotation direction of the spool should be determined according to the winding process, and the winding process needs should be fully considered in all Settings. If you buy the winding machine is not automatic winding machine, then in the operation taboo is as follows:
1. Connection of the winding machine: tie the new line with the old line before running out of use, and manually pull the guide wire to start again.
2. In the automatic working state, the body of the personnel shall not be placed in the middle area between the skeleton trough and the feeding fixture, otherwise the risk of hand clamping will occur.
3. Confirm the path of the porcelain eye and anti-jumper before starting the machine. The flywheel of the tensioner must pass the line once. Open the unloading switch to manually clamp the wire easily, must be closed before starting, otherwise the wire clamp will not be reliable.
4. In case of power failure or emergency stop, please reset and re-clamp and restart.
5. Please make sure that the electricity and compressed air are in place and can be started only after the manual state is reset.
