1.Make clamping head according to your own coil bobbin.
2.Fix the coil bobbin with the clamping head to ensure that the bobbin will not rotate freely.
3.After that,Install the clamping head into the main spindle hole of the machine and tighten the two fixing screws on both sides.
4.Then put the coil bobbin on the winding clamping head one by one.
5.Install the tensioner.
6.As shown in the picture, the wire passes through the porcelain eyelet on the thread passing plate and enters the tensioner.
7.After coming down from the tensioner guide wheel at the top of the tensioner, the thread passes through the thread clamping felt on the wire rack and enters the needle hole of the wire guide. This completes the preparation before debugging parameters







