Introduction Of Common Products Of Winding Mould

1. This kind of mould is applied to the winding of motor stator windings, which is made of several shaped pieces of wood and is characterized by long diameter and small space between shaped pieces, at present, there are also manufacturers to produce modular plastic mold, the use of automatic winding machine winding often need automatic cross-slot, users must be left in the self-made mold cross-slot required spacing, in the use of this kind of mold when winding speed should not be set too fast.                                                                                                                                                              2. Transformer winding mould this kind of mould applies to the winding of the transformer coil, generally is the long axis type stretching mould by the metal shaft plus the support composition, according to the transformer manufacturers produced by the type of transformer and technology custom-made supporting winding die, winding machine manufacturers generally provide this type of service, the use of this kind of mold is characterized by loading and unloading need to use such tools as vehicles, be sure to secure in place during installation.                                                                            3. Ballasts winding die this kind of die is generally from the left and right half of the combination of mold, mold inserted in the middle of the winding mandrel for fastening, mold is the key to the angle of the mold, the common hollow coil is also wound by this kind of mould, which is widely used in the processing of small and medium-sized winding machine.