Automatic winding machine in the process of using the skills:
Automatic winding machine operation, in fact, is not difficult, mainly on winding machine is not familiar, the company has no professional training, however, we are here for you after the introduction, I believe that people do not understand as long as the method to operate, will understand. In the process of operating automatic winding machine, we must know how to set up the winding position, enameled wire specifications, winding width three important winding parameters.
Specific methods are as follows:
1. Setting of winding position of winding machine.
What is the winding position? In simple terms, it is the starting point of winding on the skeleton. This position is closely related to the head and type of the coil. The specific value of the winding position can be measured by the measurement function of the equipment control system. Operators can also use manual measurement, with fixed point as a reference point to use ruler actual measurement, set the point to pay attention to the winding direction of the coil.
2. Specification setting of enameled wire
Our common enameled wire has different wire diameter, enameled wire specifications are set correctly will directly affect the effect of the line, the use of different materials of enameled wire need to add different wire diameter repair value, copper wire is not easy to be pulled fine, Its repair value plus about 0.02, aluminum wire after the tension of winding equipment and wire device is easy to be stretched, its repair value range between 0.02 and 0.2 is allowed.
3. Setting of winding width
The width of winding is understood as the distance between the starting position of winding and the end position of winding. Usually, the value directly reflects the length of the skeleton to be wound. When setting, it is necessary to consider the effect of the small deformation of the skeleton used on the width of winding.
