Transformer winders are made up of a number of electronic component integrated circuits, and their insulation performance is highly dependent on ambient humidity. If the humidity is too high, it will cause the circuit board to short-circuit and burn down, and if the humidity is too low, it will generate static electricity and break down part of the electronic component. Therefore, excessive humidity, too small, will bring potential threat to the transformer winding machine. Secondly, the ground vibration is big, many factories need motor to produce drag, vibration and other physical displacement movement, not only bring great noise, the severe vibration caused by the machine may bring damage to the transformer winding machine, so when the transformer winding machine is placed, the transformer winding machine should be as far away from the work site with large earthquake source as possible; If the work location can not be changed, sponges and cushioning objects should be placed under the main body of the transformer winding machine to reduce the harm caused by vibration.
The common functions of winding machines of winding machine manufacturers are preset loop number, automatic stop, forward and reverse winding, automatic cross slot, etc. , this function is to slow down the operation of the equipment after the start, in order to reduce the impact on the tension structure and enameled wire, can be set according to the actual needs of the general case of 1 to 3 laps, the stop slow function is that the equipment runs slowly before the end of the winding sequence. This function can reduce the impact on the brake and make the equipment finish the winding smoothly, especially the winding process which needs precise positioning. This parameter must be set, according to the running speed of the equipment, the parameter should also be adjusted to 2 to 5 rounds of general conditions, again is the direction of wiring and winding direction, these two parameters are the setting of the displacement direction and the rotation direction of the spindle respectively. There is a specific linkage relationship between the winding axis and the spindle of the automatic winding machine, which is controlled by the controller, setting must be clear about the direction of the displacement of the spool, many users in the debugging reflect the equipment alarm, this is because the setting error caused by equipment protection, winding machines have zero detection.
