Double Station Internal Stator Winding Machine

Double station internal stator winding machine

1. Technical requirements for stator winding

1.1. Workpiece description

A total of 1 product workpiece stator, respectively: outer diameter × inner diameter × stack height (not including the frame)

1.120mm×86mm×28mm (The outer diameter is the same, but the stack height can be adjusted.)

1.1.1 For winding requirements, please refer to Party A’s drawings. The dimensions are designed with reference to the samples provided by Party A. (Party B is only responsible for the sample size. If it is involved in a situation that is inconsistent with the sample size, Party B will not bear the corresponding responsibility, but the height can be adjusted. ).

1.1.2 The test after the equipment is wound meets the salt water pinhole test requirements of Party A (3 meters not more than 1 point), and the qualified rate of finished products is 100% within the allowable range of the parameters.

2.2 Control system:

2.2.1 Overall description of the control system

The stand-alone control system is composed of an independent main control PLC and a man-machine interface of the workstation, which can be independently debugged and operated.

Each stand-alone machine has full automatic, manual, and adjustment operation modes.

2.2.1 Interface data requirements:

The equipment has Ethernet communication function and can provide Ethernet interface to facilitate the uploading and downloading of product programs.

2.2.1 Configuration requirements:

a. Stand-alone equipment adopts independent PLC.

b. The equipment is equipped with a man-machine interface as required, with functions such as product step programming. The man-machine interface of the workstation adopts an integrated touch screen. The main functions are: product step sequence programming, real-time dynamic display of various states of the equipment, such as the actual state and position of the equipment, the ON/OFF state of various sensors, alarm information, etc., with fault diagnosis and fault query functions.

2.3 Wiring and marking requirements

2.3.1 In the electric cabinet, the plastic wiring groove in front of the board is used for wiring.

2.3.2 All electrical components must have a unique label and be installed in an eye-catching position, corresponding to the drawing for easy searching. The movement direction of the servo axis must be clearly marked. All wires and cable joints must have a unique label. All signs must comply with the national electrical standards, and the line numbers should be printed clearly and beautifully.

2.3.3 The electrical components in the electrical cabinet must be properly grounded, and the grounding wire shall be an electrical standard yellow-green wire.

Hot Tags: double station internal stator winding machine, China, suppliers, manufacturers, factory, price, made in China

SPECIFICATION